Moggens AS-531-LIGHT GREY STAERK ACETIC SEALANT 531 BOX (24 TUBES) -LIGHT GREY

The base material need to be free of dust and grease or loose material. If needed clean up with a turpentine wet rag or cloth and let it dry. Complete adhesion test before use and make sure good compatibility and viscosity of the sealant with base materials.

Application

Cut off the top of the cartridge, position the threaded adaptor to the cartridge. Cut the threaded adaptor at an angle corresponding to the joint width. Place the cartridge into the gun and inject the joint with the sealant. Apply sufficient pressure to the sealant to ensure good penetration and adhesion to the joint sides. The applied sealant should be smoothed immediately with a wet spatula or jointer to clean off excess sealant. Staerk 531 Sealant is not suitable for bonding polyethylene, polypropylene, Teflon, silicon or polystyrene based materials.

Cleaning

Clean while uncured with a turpentine cloth. After hardening remove the silicone sealant mechanically or with a silicone remover.

Healthy and safety

• Non Toxicity when cured
• If medical advise is needed have product container and label at hand
• Read label before use
• Gloves and goggles must be worn during application
• If skin contact occurs remove the sealant with cloth and wash skin thoroughly with water and detergent for a minimum of 15mins
• Avoid eye contact before curing. If this occurs rinse opened eye for several minutes under running water, then consult a doctor.
• Ensure proper ventilation at workplace or curing area.
• Keep away from children.

Storage

• Protect from freezing, store in a cool dry place at room temperature.
• Product must be used within 24 months of purchase.